Harman Infinity 3004A - Wiring for Power and Ground; Wiring for Input Signal

WIRING FOR POWER AND GROUND
At amplifier:
m
Fuse holder, fuse
! 11 Chassis ground (-)
18 " (46cm)tt
l
Battery
Remote tum-on to
aftermarket stereo REM out
(used only with low-level signal Inputs)
At ground location:
Ring Connector
Ground Wire
\
Note: Remove any paint
below ring connector
Star Washer
WIRING FOR INPUT SIGNAL
Reference 3004A low-level signals
FRONT IIEAll - OUT
...
TURH-ON I l O =
Hll
Hl1
LO
~:~.~~ -
/ ~~~level outputs ' 1
To~
From stereo rear
low-level outputs
second amplifier
low-level inputs
Note: when using low-level signals and remote turn-on lead, set
the 'TURN-ON MODE' switch to "REM' and the "INPUT LEVEL.
SWJtch to 'L O'
Reference 7005A low-level signals
TURN-ON
MOOE
DC ' Hll
......
LEVll
UM
.. ,
LO FRONT REA1t SUI
-~ i; •~ ~
~,,,~
/2:..,": •11 -•=w~
From stereo rear low-level outputs
low-level outputs
Note: when using low-level signals and remote tum-on lead with
the Reference 7005A, set the 'T URN-ON MODE" switch to •
REM '
and the SUB "INPUT' switch to 'EXT' and the "INPUT LEVEL'
switch to 'LO' .
Reference 3004A high-level signals
~~~
Screws Wires Screws
Htl
INPUT .. 1
LEVll '
~
TooP~
Stereo front
speaker wires
Stereo rear
speaker wires
second amplifier
low-level inputs
Note: when using high-level signals, set the "TURN-ON MODE'
switch to ' DC ' and the "INPUT LEVEL' switch to ' Hl1 '. If no
sound plays, change the 'INPUT LEVEL ' switch to 'Hl2 '.
Reference 7005A high-level input signals
TURN-ON ~: DC INPUT~l[ I :::
MODE LEVEL I
REM LO
INPUT l~I EXT
l81 NT
Stereo front
speaker wires
Stereo rear
speaker wires
Note: when using high-level signals with the Reference 7005A, set
the 'T URN-ON MODE' switch to 'DC', the SUB 'INPUT' switch
to iNT' , and the 'INPUT LEVEL ' switch to ' Hl1 '. If no sound
plays, change the 'INPUT LEVEL' switch to 'Hl2".