Harman JBL BAR 800 - 3 D Surround Sound Calibration

1515
www.jbl.com
English
2) Calibrate the speaker position
L
R
L
R
2
PRESS CALIBR AGAIN
CALIBRATING
2-CALIBRATION
2DONE
CALIBRATING
2-CALIBRATION
2DONE
L
R
1. Place the detachable rear speakers in your desired location.
2. On the remote control, press CALIBR.
J “2-CALIBRATION” is displayed on the soundbar.
J Countdown starts from 5 to 1.
J Calibration tone is heard. Audio calibration starts.
“CALIBRATING”: Calibration in progress
“2-DONE”: Calibration of the speaker position is
completed successfully.
1) Calibrate the listening zone
L
R
2
1-CALIBRATION1-CALIBRATION
CALIBRATING
PRESS AGAIN TO CONFIRM
1-DONE
CALIBRATING
PRESS AGAIN TO CONFIRM
1-DONE
3
1. Place the detachable rear speakers beside your seating
position.
• Make sure that the two detachable speakers have been
connected to the soundbar (See “6.1 Connect the
detachable rear speakers and subwoofer”).
2. On the remote control, press CALIBR to start calibration.
J “1-CALIBRATION” is displayed on the soundbar.
3. When “PRESS AGAIN TO CONFIRM” is displayed, press
CALIBR again.
J Countdown starts from 5 to 1.
J Calibration tone is heard. Audio calibration starts.
“CALIBRATING”: Calibration in progress
“1-DONE”: Calibration of the listening zone is completed
successfully.