EasyManua.ls Logo

Harman Mark Levinson 5101 - Connections; Rear Panel Overviews; External Component Connections

Harman Mark Levinson 5101
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
N
0
5101 STREAMING SACD PLAYER/DAC / QUICK START GUIDE
Analog Audio Output Connectors:
These balanced XLR and
single ended RCA jacks provide a line-level left-channel and
right-channel signal that can be used to send the selected
input to a pre-amplifier or integrated amplifier.
NOTE: The analog outputs must be used to listen to the
SACD layer of a Super Audio Compact Disc.
Balanced
Output Connector
(Male XLR)
Pin
3
Pin
2
Pin
1
Balanced connector pin assignments:
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Digital Audio Inputs:
The
N
0
5101
has a coaxial and an optical
S/PDIF digital audio input allowing the
N
0
5101
to function as a
stand alone DAC.
Digital Audio Outputs:
The digital audio outputs (optical or
coaxial) provide a PCM (Pulse-Code Modulation) stereo signal
to the digital input of your device, such as a Mark Levinson
N
0
5805 or N
0
5802 integrated amplifier. DSD (Direct Stream
Digital) formatted audio will not be routed to the digital outputs
due to copy protection requirements.
S/PDIF:
Supports PCM sources up to 24bit /192k.
USB Port:
This USB Type-A connector allows PCM audio
playback from USB flash drives and can also be used for
software updates.
CONNECTIONS
CONNECTIONS
REAR-PANEL OVERVIEW N
O
5101
EXTERNAL COMPONENT CONNECTIONS
Analog Outputs
Connect to the audio input of a
pre amplifier or integrated amplifier
(must be used for SACD listening)
Digital Inputs
Connect to a
digital audio source
IR Input
Connect to an
external remote
controller
12v Trigger Input
Connect to the trigger out of a
compatible device, to allow the
N
0
5101 to be switched in and out
of standby
RS232 (DB9F)
Connect to a
third party home
automation system
Ethernet (RJ45)
Connect to a network router
USB
Connect to a USB
flash memory
device containing
audio files
Wi-Fi Antenna
Connect the
supplied Wi-Fi
antenna
IEC Main AC Power Socket
Connect the supplied power
cable to an AC outlet
Digital Audio Out
Connect to the digital
inputs of a pre amplifier
or integrated amplifier