20
ERA 600 Performance Safety and Installation Manual
5. See Figure 13. Rotate the head through 180° so that you are looking at the top of the head. Remove the
six screws (arrowed) from the effects module retaining plates and keep the plates and screws for re-use.
6. See Figure 14. Slide the effects module carefully out of the head. If any wires or components become
caught, especially on the module above, move them out of the way.
7. Place the effects module on a clean work surface with the rotating gobo wheel facing upwards.
Figure 13: Removing the effects module retaining plates
Figure 14: Removing the effects module
To Next Page
Loading...
