Harman Martin MAC Aura PXL - Page 42

42 MAC Aura PXL User Guide
**Menus or menu items marked ** are available only when the fixture is connected to mains power. All other menus are available
in mains- and battery-powered operation.
TEST
(continued)**
TEST EFFECTS
BEAM DIMMER ... AURA V COLOR
WHEEL
Run test sequence of effects.
To test a specific effect, use Up/Down
buttons to scroll through groups. Press
Enter to pause and press again to restart
test sequence.
Press Menu button to exit test
TEST PAN/TILT
PA N
Run test sequence of pan functions.
Press Menu button to exit test
TILT
Run test sequence of tilt functions.
Press Menu button to exit test
MANUAL
CONTROL**
RESET Reset fixture
STROBE ... AURA COLOR WHEEL
Scroll through effects, then manually
control an effect
SERVICE
ERROR LIST Empty or up to 20 errors Display any errors in memory
FAN CLEAN** ON/OFF Start/stop fan cleaning
PT FEEDBACK**
ON
Enable pan/tilt position feedback
systems
OFF Disable pan/tilt position feedback
ADJUST**
PA N /T ILT AT EN D
STOP
STEP 1
To adjust, move head to P/T adjustment
position, then press Enter
STEP 2
To adjust, move head to P/T adjustment
position again, then press Enter
CALIBRATION**
DIMMER -30.00 ... 0.00% Set max. dimmer intensity level
RED -30.00 ... 0.00% Set max. red intensity level
GREEN -30.00 ... 0.00% Set max. green intensity level
BLUE -30.00 ... 0.00% Set max. blue intensity level
ZOOM -5.00 ... 5.00% Set zoom home position
PAN -2.00 ... 2.00% Set pan home position
TILT -2.00 ... 2.00% Set tilt home position
AURA DIMMER -30.00 ... 0.00% Set max. Aura dimmer intensity level
AURA RED -30.00 ... 0.00% Set max. Aura red intensity level
AURA GREEN -30.00 ... 0.00% Set max. Aura green intensity level
AURA BLUE -30.00 ... 0.00% Set max. Aura blue intensity level
LOAD DEFAULTS LOAD Load factory default calibration settings
SAVE DEFAULTS SAVE
Replace factory default calibration settings
with current calibration settings
USB**
NO DEVICE
No USB device present or no firmware on
USB device
UPDATING FILES
Fixture updating internal memory from
USB device
AVAILABLE
FIRMWARE
XX.XX.XX ...
XX.XX.XX
Select firmware from versions stored in
internal memory. Scroll to select version,
then press Enter and confirm your choice
to update
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
Table 6: Control menus