Harman Martin MAC Aura PXL - Service and Display Messages; Warning Message Explanations

Service and display messages 43
Service and display messages
The MAC Aura PXL gives service and maintenance information by displaying a large 3- or 4-character short
code and a smaller full-text message in the fixture’s display. The short code is visible at a distance, allowing
easier reading with the fixture still in the rig, for example, while the full-text message gives more detailed
information.
Warning messages
Warning messages indicate that either:
• problems might appear in the future if no action is taken, or
• the user needs to pay special attention to a function or procedure when working with the fixture.
The MAC Aura PXL communicates warnings as follows:
• Warning codes are shown continuously in the display and disappear when the user reacts to the warning.
• If more than one warning is detected, all warnings are displayed in sequence.
• If the display is inactive, the fixture’s status LED (see Figure 2 on page 9) flashes orange to indicate that
there is a warning. Activating the display will show the warning.
The possible warning messages are listed in Table 7 below
:
*High temperature warnings are canceled as soon as temperature returns to normal. If temperature reaches
cutoff level, the warning is replaced by a cutoff error message.
Short code
Long message and explanation
BANK
BANK NO ACCESS
Error unpacking firmware bank during/after software upload. Fixture will continue to operate on
existing firmware. Warning message is cleared by a successful software upload or at the next
power off/on cycle.
DCTW
DC TEMP HIGH
DC PCB sensor detects abnormally high operating temperature.*
LDTW
LED DRV TMP HIGH
LED driver temperature sensor detects abnormally high operating temperature.*
PFTW
PFC TEMP HIGH
PFC unit temperature sensor detects abnormally high operating temperature.*
PTTW
PT TEMP HIGH
Pan/tilt PCB sensor detects abnormally high operating temperature.*
SERV
SERVICE MODE
Fixture in service mode.
SL W
SAFETY LOOP
A safety loop error occurred but is no longer active. Warning message is cleared at the next
power off/on cycle.
UITW
UI TEMP HIGH
User interface (LCD display and control panel) PCB sensor detects abnormally high operating
temperature.*
ZFTW
ZF TEMP HIGH
Zoom PCB sensor detects abnormally high operating temperature.*
Table 7: Warning messages