Service and display messages
45
The fixture reports a calibration error if valid calibration data is not detected in EEPROM. The fixture may be
unable to read/write calibration data to EEPROM.
UELD
UPL ERR LED DRV
Could not upload new LED driver firmware during a firmware upload. Error cleared when new
firmware is uploaded successfully or power is cycled off and on.
UITC
UI TEMP CUTOFF
User interface (LCD display and control panel) temperature cutoff activated.
ZSER
ZOOM SENSOR ERR
Zoom position electrical indexing system timeout.
Short code
Long message and explanation
Table 8: Error messages
To Next Page
Loading...