"
~
~~
__
H
__
_
~
~
_ H
~
~_
~
H
~
~~
_
_~
_
~
~
INSTALLATION/CLEARANCES
- - -
~
Fireplace Insert Installation - Rear Flue - 6"Single Wall Pipe
SideWall
37"
26 ":""'--I!!!!I---1111
2.75"
NOTICE: Not for use in factory built fireplaces
with hearth weight limitations.
The Oakwood should not be installed into factory
built fireplace unless the hearth area is designed to take
the maximum weight
of
the stove.
The
Oakwood,
loaded with wood weighs approximately
500 pounds.
Mantel: extends over
3/4" from the wall.
Trim: extends less than
3/4" from the wall.
If
the fireplace floor can hold the 500 lb. Oakwood,
the stove should only be placed into the fireplace open-
ing to the point that operation
of
the damper bypass
control and the top load door operation is not compro-
mised or unsafe. (See above illustration.)
Installing in front
of
a fireplace with Mantel
Combustible
22"
16"
Harman
Oakwood
15
To Next Page
Loading...
