Harman Oakwood - The Chimney

-~ ~-
VENTING
Hole with a minimum clear-
anceoflS" (450 mm)be-
tween connector and wall
Noncombustible cover, one
side only.
If two covers are
used, each must be mounted
on noncombustible spacers at
least
7/8" (21 mm) away from
thcwall.
1"(2Smm)
AN APPROVED CANADIAN
WALL PASS-THROUGH
The Chimney
The Oakwood must be installed into a chimney
approved for use with solid-fuel appliances. In the
U.S.,
the Oakwood must be connected to (1) a prefabricated
chimney complying
with the requirements for Type HT
chimneys in the Standard for Chimneys, Factory-Built,
Residential Type and Building Heating Appliances, UL
103, or (2) a code-approved masonry chimney with a flue
liner.
In Canada, the Oakwood is listed for use with pre-
fabricated chimneys
~ested and listed to the ,high tem-
perature
(650 degrees C) chimney standard, ULC S-629,
or with a code approved masonry chimney.
The minimum recommended height for any chim-
ney is 16
ft (4.8 m) above flue collar height. For non-
mobile home installations, a round flue (either masonry or
approved prefabricated),
of either 6" (150 mm), 7" (180
mm) or 8" (200 mm) may be used. For square or rectan-
gular masonry chimneys, nominal sizes
of 8" x 8" or 8"x
12" (200 mm x 200 mm, 200 mm x 300 mm) may be used.
Codes require that solid-fuel chimneys extend 3
ft
(0.9 m) above the point at which they exit fromthe roof,
provided that no part
of any structure is within the top of
the chimney, then the chimney must extend 2 ft (6 m)
above the highest point with the 10
ft (3 m) radius top
height.
If there is hot ten feet of clearance from the top
of the chimney, then the chimney must extend 2 ft (6m)
above the highest point with the 10
ft (3m) radius.
" - ~ -~ ~~- ~ -
Minimum 12" (300
mm)tocombustibles
Minimum2" (SOmm)
Minimum 12"
Liner
(300mm) to brick
~ /FireClay
;;:: ,.... ..... ~ thimble
~
C: ___ i""o::"
.S Chimney
t5 connector
MlnrYchimnev
builtto NFPA211
specifications
AN APPROVED U.S.
WALL PASS-THROUGH
Do not connect this unit to a chimney flue
servicing another appliance.
NOTE: The restriction of not venting more than
one appliance to the same flue applies to the
U.S. specifi-
cally. While it is not recommended that you use the same
chimney for more than one appliance, in
Canada certain
exceptions may be made. Be sure to contact your build-
ing code inspection official to see
if this option is allowed
in your area, and to find out the specific requirements for
such an installation.
More than 10ft (3 m)
THE 2-FOOT, 3-FOOT, 10-FOOT RULE
Oakwood Wood Stove 17