Harman P68 - Assembly and Installation; Unpacking; Rear Cover Panels; Firebrick Installation

26
P68 Pellet Stove
The glass in your Harman stove is a special ceramic glass.
Do not abuse the glass by striking or
slamming the door.
Never burn the appliance if the door
glass is cracked or broken.
Replace only with Harman supplied
glass.
Sootand/ory-ashmayaccumulateonthe
viewing glass, and will ocassionally need to
be cleaned. Clean the glass with a soft cloth
and mild glass cleaner. Do not clean the
glass when hot, and avoid the use of abra-
sive cleaners.
Glass replacement
Carefully remove all remaining glass and
gasket materials prior to replacing the glass.
Laythedoorfacedownonaatsurface.
Remove the glass retainers and screws.
Apply the gasket material to the face of the
new glass. Lay the glass into the door, mak-
ing sure that the glass is contained within
the channels and raised areas of the door
itself. Lay the glass retainers into position and install the screws. Tighten each screw evenly to avoid making
any stress points.
•
•
•
Retainers and screws
Glass
Adhesive gasket
Door Frame
P68 Maintenance
Pelletnesmayaccumulateinthefeederbodyover
a period of time; therefore, a yearly inspection and
cleaning of this must be performed.
Tocleanoutnes:
1. Remove right rear cover panel.
2. Remove wing nuts and feeder cover on the right
side of the feeder.
3.Useavacuumcleanertoremoveallnes.
4. Reinstall feed cover, wing nuts, and right rear
cover panel.
Pellet Fines may build up in this area
5/16" Hex Head
Screws (2 on
each side)
5/16" Hex Head
Screws (2 on
each side)