Harmony Ultimate - Installation Guide; Foundation Setup; Leg Installation and Power Connection

-08-
Installation Guide
Two people are required to set up the foundaon.
NOTE: To avoid damage to the foundaon, always open the
carton while the bed is in the at posion.
Open the shipping box and take out top decking.Cut the
ribbon securing accessory Boxes&maress retainer bar
and put them aside. Carefully take out the bed frame from
packaging and open it .
1.
2. To install all six legs (see image A on the boom right), thread
the bolt of the leg to the nut on the foundaon frame, and
ghten by hand. DO NOT OVERTIGHTEN.
3. Uncoil the input power cord (connected to the control box’s
power port) and plug it into the power supply.
4. Uncoil the power cord and connect it to the power supply.
Nut on the frame is removable
and replaceable.
Please remove tape on the nut
to install legs.
WARNING