HS-3100/3200 Programming Manual
2
1.3 Addressable Devices
Supported Devices
The HS-3030 can use analog/addressable devices. There are two general types of devices:
sensors and modules. The following devices are supported:
The M500S control module can be used to control a supervised output, such as a bell or strobe
circuit. The control module monitors the circuit wiring and troubles will be reported. The module will
require a separate 24 VDC supply for the controlled circuit. When programming the database in
NP, be sure to program the control module correctly. Choose any “Control (str)” other than “Control
(relay)” for the M500S module. The HS-3400 will not operate a control module if the supervised
Modules
M500DM Dual Input Monitor Module
M500M Monitor module, Classes A/B initiating
M501M Mini Monitor module, Class B initiating
M502M Monitor Module for 2- wire smoke detectors Classes A/B
initiating
M500S Control module
M500R Relay Module
M500X Fault isolator module
IM-10
Intelligent Input Monitor Module
CZ-6
Zone Interface Module
CR-6
Control Module Relay
SC-6
Supervised Control Module
Sensors
1251 Ionization type smoke detector, low profile
1551 Ionization type smoke detector
2251 Photoelectric type smoke detector, low profile
2551 Photoelectric type smoke detector
2251T Photoelectric type smoke detector c/w heat detector,
low profile
2551TH Photoelectric type smoke detector c/w heat detector
2251TMB Acclimate Photo-Thermal Detector
5251 Fixed temperature detector, low profile
5251H Fixed high temperature detector
5551 Fixed temperature detector
5251R Rate of Rise and fixed temperature detector, low profile
5551R Rate of Rise and fixed temperature detector
To Next Page
Loading...
Need help?
General
