12
Lighting Procedure
Because a downdraft fire operates differently from a traditional fire, it is important to follow these
steps to ensure the fire will operate as intended and to ensure a clean and efficient light up.
What you will need:
• Approximately 16 pieces of kindling wood, about 1kg in weight
• 4 x pieces of small sized wood (intermediate load 1), approximately 300mm in length, 1.2kg
in weight (total)
• 4 x pieces of medium sized wood (intermediate load 2), approximately 300mm in length,
2.5kg in weight (total)
• 2 x fire lighter cubes
• 1 x long handle lighter
Step 1.
Loading the kindling wood
Stack the 16 pieces of kindling wood in a ‘cross stack’ style with the 2 fires lighter placed at the
front of the stack.
Important: Ensure installation instructions have been adhered to before lighting the appliance.
For your comfort, it is advised that you light your first fire with the windows open to allow the es-
cape of paint fumes. This will normally happen for the first 30 minutes of the first burn. Ensure the
fire is run at a high temperature during this period.
To Next Page
Loading...
General