1 – English
HACRM02 Bagging Kit With Boost
For Use With HART 30 In. Lithium Riding Lawn Mower
WARNING:
To reduce the risk of injury, user must read and under-
stand the operator’s manual for their riding lawn mower
before using this accessory. Save these instructions.
Refer to them frequently and use them to instruct other
users. If you loan someone this product, loan them
these instructions also.
PACKING LIST
Bagging Blades (2) Bagger Bracket
Hitch Pin Bagger Cover
Bags (2) Upper Bagger Tube
Lower Bagger Tube
INSTALLING THE BAGGING KIT
The HACRM02 Bagging Kit is compatible with HART
H80RM01 lithium riding mower. This kit includes a bagger
and special mower blades designed to be used when bag-
ging. Install the blades first, then install the bagging kit.
REMOVING THE CUTTING DECK
See Figure 1.
If desired, the cutting deck can be removed from the mower
to make accessing the blades easier when changing.
Stop the motor, remove the start key, and set the parking
brake.
Disconnect the cables that connect the cutting deck to
the mower.
Lower the cutting deck to its lowest position.
Remove the 4 hitch pins and washers that secure the
cutting deck in place.
Slide the deck out from under the mower.
Reverse the process to reattach the cutting deck to the
mower.
INSTALLING BAGGING BLADES
See Figures 2 - 3.
CAUTION:
Only use replacement blades and nuts authorized by
the manufacturer of your riding mower. Use of blades
and nuts not authorized is hazardous and may damage
your riding mower.
Make sure the blade is not engaged.
Stop the motor, remove the start key, and set the parking
brake.
Raise the height of the cutting deck to its highest position
to allow access to blades.
FIG. 1
NOTE: If necessary, raise the mower by placing on a lift
or using a jack and jack stands, or remove the cutting
deck as described in the previous section to gain access
to the blades.
CABLE
CUTTING
DECK
HITCH PIN
WASHER
BLOCK OF WOOD
BLADE
WRENCH
FIG. 2
To Next Page
Need help?
General
