HART HGHST01 - TROUBLESHOOTING; Line Feed Issues; Grass Wrapping; Motor Start Problems

12 – English
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Linewillnotadvancewhenusing
the auto-feed head
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Lubricate with silicone spray.
Install more line. Refer to Line Replace-
ment earlier in this manual.
Pulllinewhilepressingbutton.
Remove line from spool and rewind.
Refer to Line Replacement earlier in
this manual.
Grass wraps around boom
housing and string head
Cuttingtallgrassatgroundlevel. Cut tall grass from the top down to pre-
ventwrapping.
Motor fails to start when switch
trigger is depressed
Battery is not secure.
Battery is not charged.
To secure the battery pack, make sure
the latches on each side of the battery
pack snap into place.
Charge the battery pack according to the
instructions included with your model.