HART HGSP02 - Page 15

11 – English
REPLACING SEALS
See Figure 14.
WARNING:
Always follow procedures for draining and cleaning
the tank before replacing the seals. Make sure you
wearrubbergloveswhenreachingintothechemical
tank.Washyourhandsthoroughlyafterwards.Failure
to follow these instructions can result in a rash, skin
irritation,orotherseriouspersonalinjuryifyoudirectly
contactsomechemicals.
Over time, seals can harden and crack, which can allow
thechemicalsprayertoleak.Refertotheimageshownfor
the location of each of the seals, then replace as needed to
addressanyleaksthatdevelop.
Additional sets of replacement seals can be ordered by
contactingcustomerservice.
NOTE: Unthreading the connections to replace the seals
could allow liquid to escape, so always clean the chemical
sprayerthoroughlyaspreviouslydescribedbeforereplac-
ingtheseals.
MAINTENANCE