HART HGSP02 - Maintenance and Cleaning

10 – English
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
anymaintenance.
WARNING:
Alwaysweareyeprotectionwithsideshieldsorgoggles
markedtocomplywithANSIZ87.1alongwithbreath-
ingprotection.Failureto do socould resultin fluids
enteringyoureyesresultinginpossibleseriousinjury.
WARNING:
Whenservicing,useonlyidenticalreplacementparts.
Useofanyotherpartsmaycreateahazardorcause
productdamage.
WARNING:
Periodicallyinspect theentireproductfordamaged,
missing, or loose parts such as screws, nuts, bolts,
caps,etc.Tightensecurelyallfastenersandcapsand
do not operate this product until all missing or damaged
partsarereplaced.Pleasecontactcustomerserviceor
anauthorizedservicecenterforassistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plasticsaresusceptibletodamagefromvarioustypes of
commercialsolventsandmaybedamagedbytheiruse.Use
cleanclothstoremovedirt,dust,oil,grease,etc.
WARNING:
Do not at any time let brake fluids, gasoline, penetrating
oils,etc.,comeincontactwithplasticparts.Chemicals
can damage, weaken, or destroy plastic which may
resultinseriouspersonalinjury.
MAINTENANCE
CLEANING THE UNIT
See Figure 12.
WARNING:
Alwaysstoreanddisposeofchemicalsproperly.Dis-
posal of contaminated rinse water should be performed
accordingtolocalordinancesandbylaws.
Draining the Tank
If there is any liquid left in the tank after spraying, the tank
shouldbedrainedbeforecleaning.
Removethebatterypack.
Removethe motor housingfrom the tankby lifting up
andreleasingthelatchesoneachendoftheunit.
Drainthecontentsofthetankthroughthefillarea.
NOTE: Drainthecontentsbackintotheoriginalcontainer.
Donotstorechemicalsinthetank.
Cleaning the tank and spray wand assembly
Fillthetankaboutone-thirdfullwithcleanwater.Asmall
amountofmildhouseholddetergentmaybeadded.
NOTE: Neveruseflammablechemicalsorabrasiveclean-
ingagentstocleanthetank.
Wipetheoutsideofthetankwithaclean,drycloth.
Reattachthemotorhousingtothetank.Makesurethe
latchesareclosed.
Reinstallthebatterypack.Sprayuntilthetankhasbeen
emptied.Makesuretodirectthespraytowardanarea
thatwillnotbedamagedbythespraysolution.
Refillandrepeattheprocedurewithcleanwater.Itmay
be necessary to rinse the tank more than once, then drain
againasdirectedabove.
Allowallpiecestocompletelydrybeforereinstallingparts
andstoringtheunit.
CLEANING THE NOZZLE
See Figure 13.
Ifthenozzlebecomesplugged,usethestepsbelowtoclear.


Removethebatterypack.


Unscrewandremovetheadjustablenozzlefromthespray
wand.


Pushasmallwirethroughthecrossholestoclearany
debris.Ifnecessary,rinsethecrossholesandnozzlewith
cleanwater.


Wipethenozzleandcrossholeswithacleandrycloth
andreinstallthenozzle.