Why is my HART HLPM02VNM not starting?
Your HART Lawn Mower might not be starting due to a low battery, missing start key, or the handle not being in the correct operating position. To resolve this, charge the battery, install the start key, and ensure the lower and upper handles are raised.
What to do if HART HLPM02VNM is vibrating at higher speed?
If your HART Lawn Mower is vibrating at a higher speed, it could be due to an unbalanced, excessively, or unevenly worn blade, or a bent motor shaft. Replace the blade. Then, stop the motor, remove the start key and battery, and inspect for damage. Have it repaired by an authorized service center before restarting.
How to fix HART Lawn Mower handle not in position?
If the handle of your HART Lawn Mower is not in position, it may be because the handle adjustment knobs and/or handle lock clips are not secured. Make sure the handle adjustment knobs are fully seated and the handle lock clips are fully closed.
Essential safety guidelines for operating the lawn mower.
Rules for safe mowing, handling foreign objects, and slope operation.
Instructions for installing the battery pack and starting the mower.
How to use the self-propelled feature and adjust cruise control.
Identifies problems and suggests solutions for mower malfunctions.
General| Voltage | 40 V |
|---|---|
| Motor Type | Brushless |
| Deck Material | Steel |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge | Yes |
| Number of Batteries Included | 2 |
| Power Source | Battery |
| Cutting Width | 20 inches |
| Drive System | Rear Wheel Drive |
| Battery Amp Hour | 4 Ah |
| Cutting Height | 1.5 - 4 in |
To Next Page
