EasyManuals Logo

HART HLPM03 User Manual

HART HLPM03
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
12 – English
MAINTENANCE
REPLACING THE CUTTING BLADE
See Figures 16 - 17.
NOTE:
Onlyuseauthorizedreplacementblades.
Stopthemotorandremovethestartkey.Allowtheblade
tocometoacompletestop.
Removethebatterypackfromthebatteryport.
Turnthemoweronitsside.
Wedgeablockofwoodbetweenthebladeandmower
decktopreventthebladefromturning.
Loosenthebladenutbyturningitcounterclockwise(as
viewedfrombottomofmower)usinga15mmwrenchor
socket(notprovided).
Removethebladenut,spacer,bladeinsulator,andblade.
Do not removethehubortheadaptor.
WARNING:
Ifthehuband/ortheadaptorhavebeenremoved,re-
placethembeforeplacingbladeontheshaft.Failure
todosocouldcausethebladetodetachorbecome
unbalancedsincebladewillnottightenproperly,which
canresultinseriouspersonalinjury.
Placethenewbladeontheshaftagainstthebladeposts
onthehub.Ensurebladeisproperlyseatedwithshaftgo-
ingthroughcenterbladeholeandthetwobladepostson
thehubinsertedintotheirrespectiveholesontheblade.
Makesureitisinstalledwiththecurvedendspointingup
towardthemowerdeckandnotdowntowardtheground.
Whenseatedproperly,thebladeshouldbeflat.
Replacethebladeinsulatorandspacer,thenthreadthe
bladenutontheshaftandfingertighten.
NOTE:Makecertainallpartsarereplacedintheexact
orderinwhichtheywereremoved.
Torque the blade nut down clockwise using a torque
wrench(notprovided)to ensure the bolt is properly
tightened.Therecommendedtorqueforthebladenutis
310–360in.lbs.
WARNING:
Ensurebladeisproperlyseatedandthebladenutis
tightenedtothetorquespecificationsabove.Failureto
properlyattachthebladecouldcauseittocomeloose
andresultinpossibleseriouspersonalinjury.
STORING THE MOWER
See Figures 18 - 20.
WARNING:
Removeallbatterypacksfromthebatteryportandbat-
terystoragecompartmentandstartkeyandstoreina
securelocationoutofthereachofchildrentoprevent
unauthorizeduseofthelawnmowerandpossibleseri-
ouspersonalinjury.
nBeforestorage,wipeanydirtordebrisfromthebattery
area.
nTurnmoweron itssideand clean grassclippings that
haveaccumulatedontheundersideofthemowerdeck.
nWipethemowercleanwithadrycloth.
nCheckallnuts,bolts,knobs,screws,fasteners,etc.,for
tightness.
nInspectmovingpartsfordamage,breakage,andwear.
Haverepairsmade onanydamaged ormissing parts.
Checkbladefordamage,uneven,orexcessivewearand
replacebladeiftheseconditionsexist.
nStoremowerindoorsinaclean,dryplaceoutofthereach
ofchildren.
• To storethe mower in a horizontal position, lower
thehandleassembly.Avoidpinchingortrappingany
cables.
• Tostorethemowerinaverticalposition,removethe
grass bag, then lower the handle assembly. Avoid
pinchingortrappinganycables.Raisethemower90°
torestonitsrearsupport.
NOTE:Makesurethepinsonthehandleadjustment
knobsarefullylockedbeforeattemptingtoraisethe
mowertothestandingposition.
NOTICE:
Donotallowthestartercabletobecomepinchedor
trappedwhenloweringthehandle.
nDonotstorenearcorrosivematerialssuchasfertilizeror
rocksalt.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HART HLPM03 and is the answer not in the manual?

HART HLPM03 Specifications

General IconGeneral
BrandHART
ModelHLPM03
CategoryLawn Mower
LanguageEnglish

Related product manuals