HART HPAD01 - Page 7

7 – English
OPERATION
BLUETOOTH
®
enableddevicesmustbewithin30ft.of
theradioandsettosearch/scaninordertopairwiththe
radio.
Select“HartRadio”fromyourdevice’slistofavailable
BLUETOOTH
®
signalstopairthedeviceandtheradio.
NopasswordorPINisrequiredforconnection.
Whenthedevicehassuccessfullypairedwiththeradio,
theword“BLUE”willstopflashing.
NOTE:Whenadeviceispairedtotheradio,information
for connecting to the device is saved in the radio’s
memory.
When streaming audio from a BLUETOOTH
®
 enabled
device,presstheSCANleftandrightarrowbuttonsto
gotothepreviousornexttrack.Brieflypressandrelease
the PRESETbuttontocyclebetweenpausingandplaying
theaudio.
NOTE: These controls may not be supported by the
BLUETOOTH
®
deviceand/orapplicationyouareusing.
AllBLUETOOTH
®
enableddevicecontrolscanbeused
normallywhilepairedtotheradio.
NOTE: Volumeforanydevicepairedtotheradiocanbe
adjustedusingthevolumecontrolforthatdeviceorby
usingtheradio’sVOL + or VOL – button.
To disconnect the BLUETOOTH
®
 enabled device,
pressandholdthePRESETbutton.Whenthedeviceis
disconnected,“bt”willbeginflashingintheLCDdisplay
andtheradiowillbeginsearchingforanotherdevice.
USING THE USB DEDICATED CHARGING
PORT
TheUSBdedicatedchargingportprovideschargingpower
of5VoltsDCatupto1Ampforyourcellphone,MP3player,
orotherUSBdevices.
NOTICE:
Attemptingtochargedevicesratedmorethan1Amp,
such as a tablet, could damage the USB dedicated
chargingportand/orthedevice.
ConnectoneendofaUSBcable(notprovided)toyour
USBdevice.
ConnecttheotherendoftheUSBcable(notprovided)to
theUSBdedicatedchargingporttobeginchargingthe
device.
NOTE: The USB dedicated charging port provides
poweronly;itdoesnotprovideanydatacommunication
capabilities.