Need help?Do you have a question about the Hartke HA5500 and is the answer not in the manual?
General| Type | Bass Amplifier |
|---|---|
| Number of Channels | 2 |
| Tube | No |
| Effects Loop | Yes |
| DI Output | Yes |
| Power Output | 500W |
| Preamp | Solid State |
| Inputs | 1 x 1/4" |
| Speaker Outputs | 2 x 1/4" |
| Outputs | 1 x XLR |
Master volume sets overall loudness; power switch turns the unit on/off, LED indicates power status.
1/4" jacks for connecting 4, 8, or 16 ohm bass cabinets; requires appropriately rated speakers.
XLR output for consoles; Pre/Post EQ switch and Ground Lift switch for signal routing and noise reduction.
Connect speaker cabinets, AC power, and bass guitar; set initial control levels.
Turn on amplifier after setup; slowly adjust Master Volume while playing for desired level.
Ten sliders adjust +/-15dB across specific frequencies for detailed tonal shaping.
To Next Page
