PLEASE KEEP ME WITH YOUR PROOF OF PURCHASE FOR FUTURE REFERENCE.
For replacement or lost spare parts please go to http://faq.hartmanuk.co.uk/spares/
Should you have any queries about your furniture your first point of contact should be the retailer from whom
you purchased your product.
ATTENTION:
1. Please read these instructions carefully before assembly
2. Aluminium is soft metal and over tightening may strip thread or break the part
3. DO NOT use power tools however you will require an allen key to assemble product.
4. Please allow 30 minutes for assembly.
5. Although assembly only requires 1 person it is advised that a second person be present to help turn the chair over and into position when
fully assembled.
ASSEMBLY STEPS:
1. LOOSELY attach the centre ring (B) to the legs (C). Secure these using bolts (J) small flat washers (K), and small lock washers (L).DO
NOT TIGHTEN BOLTS AT THIS STAGE
2. Turn the table top (A) upside down on a soft clean surface.
3. Using flat head screw driver screw the bolts (E) into the table top.
4. LOOSELY attach the legs (C) to the table top at the points where the bolts (E) have been placed. Then slide big flat washers (F), big
lock washers (G), and nuts (H) on to the bolt. DO NOT TIGHTEN NUTS AT THIS STAGE
5. Tighten all the bolts (E/J) using the allen key (N) one by one being careful not to over tighten any, as this will cause the thread to become
damaged.
6. Place PVC covers (M) on all visible bolt heads (J) and nut caps (I) on all visible nuts (H)
7. Turn the table onto its legs， screw in adjustable feet(O) and place in desired position
For more information regarding maintenance of your furniture and to register your
warranty, please visit www.hartmanuk.com
60903062A
60903053A
60903088A
60903062B
60903053B
60903088B
60903062C
60903053C
60903088C
To Next Page
Need help?
General