Need help?Do you have a question about the HARWI ORCA Series and is the answer not in the manual?
Details about the machine manufacturer, Harwi Holland B.V.
General information about the Orca vertical panel saw machine.
Specifications including cut dimensions, speeds, power, and machine weight.
Details on noise levels during operation, including safe deviation.
Instructions for placing and securing the machine on a flat, solid floor.
Requirements for connecting the machine to a dust extractor system.
Steps to release the counterweight mechanism on the vertical slide way.
Adjusting the measure for horizontal cuts using midway fences.
How to use the locking controller for vertical cutting of plastic strips.
Using panel supports to prevent damage during horizontal cuts.
Routine cleaning procedures for the machine's work spots and strips.
Inspecting and replacing worn brushes on horizontal tracks.
Procedure to smoothen the midway fences for accurate cuts.
Procedure to smoothen the bottom supports for accurate cuts.
Re-adjusting pointers for measuring midway fences and bottom supports.
Setting the length stop for precise horizontal cuts.
Adjusting the scoring blade's position to forward or backward.
Adjusting the scoring blades for desired groove width.
Aligning the scoring blade relative to the main saw-blade.
Setting the digital read out based on bottom support measurements.
Setting the digital read out based on midway fence measurements.
Setting the digital read out based on the material's top side.
Checking and re-adjusting the digital read out's off-set value.
Re-adjusting the absolute reference point for supports and fences.
Re-adjusting the reference point for midway fences.
General| Brand | HARWI |
|---|---|
| Model | ORCA Series |
| Category | Power Tool |
| Language | English |
To Next Page
