Need help?Do you have a question about the Hasbro Retaliator and is the answer not in the manual?
Assemble the string and hook by feeding string through the lower body half connector bar.
Install the string by tying a knot to the tail fan and winding it counterclockwise.
Snap the left and right tail fans over the posts on the rear of the chopper.
Assemble the bomb slider by placing the gun between its grooves and securing landing skids.
Place the landing skids into the notches on the bomb slider.
Slide the assembled bomb slider onto the underside of the chopper front end.
Snap the bomb ramp into body grooves and load bombs into the chutes for release.
Snap the nose cap over the front of the chopper.
To Next Page
General