-
-
ADULT
ASSEMBLY
REQUIRED.
UkSe'anlyrrPaAetm
Dorotlaardlany
~mole.Mustbephyd
BUILD
THE
TOWER
1.
Remove
the
tower pieces
from
the
box.
2.
Lave
the
sliding
mde
setufed
te
the
center
misn
of
the
twa
for
now.
-
partion
of
the
tower first
grasping the lower and middle
se&r)m, &king
sure
to keep your fingers away from
the
hinge, and carefully pushing them together until
they
kk into place. Repeat this for the upper portion.
IMPOW7ANE DO NOT pull out
or
remove tfre wires.
Secured
Mole
I
v
4.
After lacking
.the
tower
sdons together,
use
a
Phillips head screwdriver
to
tighten the four
Mack
screws on
the
back side
of
the
tqr.,
TMis
will
m-4
wmr tower
sectims
dPmmain
lded
together.
Contents
3-Piece Hinged
Tower
with
Sliding
Mole
Cardboard Tower Topper
Tower Base Mallet
Tower
m
WWRE
THE
TOWER
RASE
Insert the assembled tower into
the base and snap
it
into place.
IMFORTANE DO NOT pull on or
attach anyfhing to the connector
pegs
or base
contacts.
Am3MEmWER.n
--
-
Cardilly fit the cardboard tower
topper over the bell and into the slot.
UNLEASH
THE
MOLE
Now, release the
sliding mole.
IMPORTANT
This game is not
intended
to
be
disassembled.
To Next Page
Need help?
General
