To Next PageTo Next Page
Need help?Do you have a question about the HASE Bikes 25403 and is the answer not in the manual?
General| Brand | HASE Bikes |
|---|---|
| Model | 25403 |
| Category | Bicycle Accessories |
| Language | English |
Shift the chain down to the smallest cog of the cassette for derailleur alignment.
Remove the M8 bolt and locknut from the tracking adjustment tube.
Align shifting unit parallel to delta tube and derailleur arm to tracking adjustment tube.
Tighten the M8 bolt and locknut of the tracking adjustment tube.
Position cable clamping pin relative to brake plate for 9 or 11-speed derailleurs.
Position clamp so gear cable runs parallel to the derailleur plate.
Shift the chain down to the smallest cog of the cassette before adjustment.
Loosen clamp bolt, pull gear cable tight, and retighten.
Set low limit screw for chain and chain guide alignment with smallest cog.
Set high limit screw for chain and chain guide alignment with largest cog.
Loosen bolt and slide cable clamping pin outwards to increase gear interval.
Loosen bolt and slide cable clamping pin inwards to decrease gear interval.
