How to prevent and adjust roller moiré (puckering)
In the case where roller moiré has taken place on the fused material, fuse it by
lowering heat and pressure as low as possible. Even when the prevention is
impossible in spite of the efforts, adjustments to be shown below will be
necessary.
1. Remove the main unit’s cover.
2. Remove the rear cover.
3. You’ll find a screw for securing the moiré adjust roller on the side of the
machine . And you will find an other when you open the rear cover of the
machine loosen both of the stop screws and rise right and left equally.
4. The moiré is hard to appear when you bring up the roller.
5. Tighten both of the stop screws.
How to move the machine by hand at the emergency
Press the stop switch in order to stop the machine before setting the pressure to 0
(zero), when you’ve put other things to the belt’s injecting entrance by mistake.
Put the T-typed wrench (an accessory) on to the screw for emergency on the side of
the main unit and turn it to the arrow marked direction, before you will unload
the finished material. In the case where a hard thing has been put in the machine,
ensure the safety before resuming the operation for fear that the teflon belt and
rubber parts of the pressure roller might be damaged. And in the case of an
To Next Page
Loading...