Cleaning the brush scraper.(C)
The brush, too, is provided at the rear part of the main unit of the machine. Raise the scraper
three or four times a day in order to clean.
Cleaning the rotary strip off blade (CS)
Pick the blade, using a piece of the cloth and move it left to right and right to left
in order to take the fusing resin resin and others away. Here. if the blade remains
lying ,raise it before cleaning it.
ATTENTION TO BE PAID MAINTANANCE OF FUSING MACHINE
Put-off electric sources, fill “grease” inside rollers every two weeks
You should use HASHIMA genuine grease and never use grease which contains
MOLYBDENUM (LACK OF THIS GIVES DAMAGES TO BEARINGS)
1. TAKE OUT MAIN COVER A.
2. FULL GREASE INTO THE PLACE OF ARROW MARKS.
To Next Page
Loading...