HASHIMA HW-40C - Assembly; Operation Method

HW- 4 0
-®
Operatidn ~thDd:
tll Place the spool on the turniflg shaft.
(2)
There are two kinds of fixing screws.
When f. i:x.i ng the _ spoo .J. to tfl .e right h . a~d
side tumin~ shaft use tl1e fixiflg sp.ool
wi . th a brim. when fixing the spool to
the
left hand
side turn in~
sll:a f t use
th ·e r i :rrng spool without a brim.
Thread the
thread
throught the
insulated hole on
the arm(l).
Instructiofi Maunal
Asserrbly instructions
(I) Connect the stand s. haft{l3)to the mai.n unit.
using the nut(l2)and the flat wasber(ll).
(21 Add the a·rms(l'O)and the insulated ar.ms(l).
(3) Fix t· he fixing pin(3) onto the ar.m(IO) tisillg
the fIat washer(6) spring washer(7) and H1~
nut(8).
(4) To the fixing pin(3) apply the rece·iver(S).
sp.ong.e(4) and the b.obbiR .1Jolder(2) . .
!5) ~ppl y the rubber cap(9) t.a t:Je top ~t t!'..e
.s taR.d shaU(l3 ).
(Attention)
Pull the power source plug e. t:ft of the
conse~t e~cept when wsin9.
from ARM
(3)
Next thread the thread throught the ho l e.
in the tension guide. wind the thread
around the tension
disk and back through
the
hole in the tension guide.·
!41 Next the thread is passed throught the
ho.l e in the thread guide from the top.
dawn and winds around the spool.
tension
~uide
!Sl Turn the rimer to the right and the
From the library of: Superior Sewing Machine & Supply LLC