Need help?Do you have a question about the Haskris LX1 and is the answer not in the manual?
General| Brand | Haskris |
|---|---|
| Model | LX1 |
| Category | Refrigerator |
| Language | English |
Details physical dimensions for standard configurations of LX1, LX2, and LX3 models.
Specifies minimum clearance requirements for air flow, access, and service.
Provides guidance on selecting an appropriate installation environment for the chiller.
Offers recommendations for selecting pipe sizes based on flow rates and lengths.
Outlines compliance with codes, material selection, insulation, and valve installation.
Covers electrical code compliance, installation by electricians, and power connection.
Details the procedure for filling the unit's reservoir with clean, distilled water.
Explains how to set the switch for 50Hz or 60Hz incoming electrical frequency.
Describes the location and function of the chiller's rocker ON/OFF switch.
Details the process to fill the pump head with fluid before operation.
Guides on adjusting the bypass pressure relief valve setting for optimal performance.
Lists final verification steps for flow, pressure, and system integrity before operation.
Explains the data shown on the main controller display screen.
Describes the different operational status modes of the chiller.
Provides steps to change the adjustable set value on the controller.
Details how to select preferred units of measure for display.
Explains how to identify, display, and reset faults on the chiller.
Lists various remote communication options available for the chillers.
Covers wiring and configuration for Modbus and BACnet communication.
Details cleaning procedures for condenser coils to maintain performance.
Explains checking and cleaning the suction strainer to prevent pump damage.
Describes maintenance for the particle filter that captures debris.
Guides on cleaning the wye strainer for water-cooled condenser units.
Covers maintaining water level, pH, cleanliness, and flushing procedures.
To Next Page
