To Next PageTo Next PageWhat to do if my Hatco Dispenser is not working?
If your Hatco Dispenser isn't working, first ensure the unit is turned on by moving the POWER ON/OFF switch to the ON position and that it is properly plugged into a power supply. Also, check if the circuit breaker has tripped and reset it if needed. Make sure the unit is supplied with water to prevent low-water cut-off activation. If the issue persists, the POWER ON/OFF switch may be defective.
Why is my Hatco AWD not dispensing water?
If your Hatco Dispenser isn't dispensing water, ensure the drain valve handle is in the closed (horizontal) position and that the water supply is turned on. Also, the dipswitch settings might be incorrect or the high temperature safety switch may have been activated.
How to fix Hatco Dispenser water not hot enough?
If the water from your Hatco Dispenser isn't hot enough, the temperature setpoint might be set too low. Also, the heating elements may be defective or the voltage supplied to the unit may be incorrect.
General| Model | AWD Series |
|---|---|
| Material | Stainless steel |
| Category | Water Dispenser |
| Application | Commercial |
| Type | Water Dispenser |
| Capacity | 1, 3, or 5 gallons (depending on the model) |
| Power | Varies by model |
| Features | easy to clean |
| Dimensions | Varies by model |
| Weight | Varies by model |
Complete online warranty registration for prompt coverage and assistance.
Provides business hours, phone, email, and fax for service support.
Crucial safety guidelines for preventing electric shock during operation and maintenance.
Warnings about hot exterior surfaces and water temperatures to avoid burns.
Covers explosion hazards, proper installation, water quality, and general unit handling.
Details features, control panel, standard equipment, and naming conventions for dispensers.
Information on electrical plug types, voltage, power, amperage, and shipping weight.
Provides detailed physical measurements of the AWD-12 model.
Shows recovery rates at different temperature rises and flow rates.
Details time required for heating and recovery after dispensing.
Step-by-step guide for installing the Atmospheric Hot Water Dispenser.
Procedures for turning the unit on, off, and initial setup.
Instructions on how to dispense hot water using the unit's controls.
How to adjust the water temperature setpoint using dipswitches and buttons.
Procedure to modify the water quantity dispensed by programmed buttons.
Routine cleaning and upkeep to maintain performance and appearance.
Steps for safely draining water from the unit for maintenance or relocation.
Addresses issues like unit not working, no water, or water not hot enough.
Explains the meaning of displayed error codes (E1, E2, E3, H2O).
Guide for installing the optional water filtration system.
Information about the available locking plug for electrical connections.
