Haulotte H14TX - User Manual

Questions and Answers

A
Austin MasonAug 25, 2025
How to fix unresponsive platform controls without a buzzer on my Haulotte H14TX Construction Equipment?
- A
  Alyssa GutierrezAug 26, 2025
  If the platform controls are unresponsive without a buzzer, check these potential causes: * Ensure the ground control box selector key is set to the platform control box position. * Verify that the 'Enable Switch' control validation device is enabled and kept pressed down during movement. * Not enough hydraulic oil - top up the oil level.
P
Patty MillsNov 3, 2025
Why won't my Haulotte H14TX Construction Equipment engine start or stop?
- Q
  qsmithNov 3, 2025
  There are several reasons why the engine may fail to start or stop: * The fuel tank might be empty, so fill it. * The batteries could be discharged; recharge them. * Printed circuit fuses in the ground control box might be faulty; replace them. * E-stop push-buttons might be pushed in; pull them out. * The engine may be in restricted mode, indicated by oil pressure, overheating, alternator charging, and clogged air filter indicators; in this case, consult the engine manufacturer's manual or contact HAULOTTE Services®. * The charge indicator bulb could be burnt out; replace it. * The air filter could be clogged; replace the air filter cartridge. * The engine safety relay might be faulty; replace the relay. * There could be poor cable/battery terminal contact; loosen and c...
N
nicholas98Nov 13, 2025
What to do if platform controls do not respond on my Haulotte H14TX (buzzer sounding)?
- R
  Randy JamesNov 13, 2025
  If the platform controls do not respond and the buzzer is sounding, consider the following: * You might have a platform overload; remove some weight to stay within the authorized limit. * The tilt or slope may exceed the authorized limit; retract the telescope, lower the boom, and correct the tilt. * If there's no high speed, the platform might be extended; lower the boom as far as possible. * If there's no steering, there might not be enough hydraulic oil; top up the oil level. * Ensure the 'Enable Switch' control validation device is enabled and kept pressed down during movement. * If there's no turntable rotation, the turntable rotation locking pin might be inserted in the chassis; remove the pin. * An abnormal noise from the hydraulic pump or pump cavitation indicates no...