Haussmann HLG033 User Manual

gb
28
5. Run engine at idle until unit stops. This
will purge the carburetor of fuel.
6. Allow engine to cool (approx. 5 minutes).
7. Using a spark plug wrench, remove the
spark plug.
8. Pour 1 teaspoon of clean 2-cycle oil into
the combustion chamber.
9. Pull starter rope slowly several times to
coat internal components.
10. Replace spark plug.
11. Store unit in a cool, dry place away from
any source of ignition such as an oil
burner, water heater, etc.
Removing a unit from storage
1. Remove spark plug.
2. Pull starter rope briskly to clear excess
oil from combustion chamber.
3. Clean and gap spark plug or install a
new spark plug with proper gap.
4. Prepare unit for operation
5. Fill fuel tank with proper fuel/oil mixture.
See fuel and lubrication section.
TrOUbLESHOOTINg
Problem
Unit won’t start or
starts but will not
run
Unit starts, but
engine has low
power
Engine hesitates
No power under
load
Problem cause
1. Incorrect starting procedures
2. Incorrect carburetor mixture
adjustment setting
3. Fouled spark plug
4. Fuellterplugged
1. Incorrect lever position on
choke
2. Dirtyairlter
3. Incorrect carburetor mixture
adjustment setting
1. Incorrect carburetor mixture
adjustment setting
1. Incorrectly gapped spark
plug
Corrective action
1. Follow instructions in the user
manual
2. Have carburetor adjusted by
an authorized service facility
3. Clean / gap or replace plug
4. Replacefuellter
1. Move to RUN position
2. Remove, clean and reinstall
lter
3. Have carburetor adjusted by
an authorized service center
1. Have carburetor adjusted by
an authorized service center
1. Clean / gap or replace plug
MAINTENANCE

Haussmann HLG033 Specifications

General

Brand	Haussmann
Model	HLG033
Category	Trimmer
Language	English