Haussmann HLG033 User Manual

gb
v.080116 27
AIr FILTEr
Neveroperatetrimmerwithouttheairlter.
Theairltermustbekeptclean.Ifitbecomes
damaged,installanewlter.
To clean Air Filter:
1. Press down on tab that is holding the air
ltercoverinplace.Removecoverand
liftlterfromairbox
2. Washthelterinsoapandwater.DO
NOT use gasoline!
3. Airdrylter.
4. Reinstalllter.
Replacethelteriffrayed,torn,damagedor
unable to be cleaned.
FUEL FILTER (Fig. 8)
Remove fuel from unit and store in approved
container before starting this procedure. Open
fuel cap slowly to release any pressure which
may have formed in fuel tank.
1. Liftfuellineandlteroutoftank.Asteel
wire with a hook or a paper clip works
well.
2. Pull off with a twisting motion.
3. Replacefuellter.
Never operate the trimmer without the fuel
lterinplace.Internalenginedamagecould
result!
WArNINg
!
IMPOrTANT
!
WArNINg
!
WArNINg
!
Fig 8
Fuel line
andlter
SPARK PLUG (Fig. 9)
1. Spark plug gap = .635 mm (.025”)
2. Torque to 105 to 130 inch pounds (12 to
15 Nm)
3. Connect spark plug boot.
DEbrIS SHIELD KNIFE SHArPENINg
(Fig. 10)
1. Remove cutter knife from the debris
shield.
2. Place knife in a bench vise. Sharpen
knifeusingaatle,beingcarefulto
maintain the angle of cutting edge. File
in one direction only.
STOrINg A UNIT
Failure to follow these steps may cause
varnishtoforminthecarburetoranddifcult
starting or permanent damage following stor-
age.
1. Perform all the general maintenance
recommended in the maintenance
section of your Instruction Manual.
2. Clean exterior of engine, drive shaft
assembly, debris shield, and linehead.
3. Drain fuel from the fuel tank.
4. After fuel is drained, start engine.
Fig. 9
.025” (.635 mm)
WArNINg
!
Fig. 10
Debris shield
Cutter knife
MAINTENANCE

Haussmann HLG033 Specifications

General

Brand	Haussmann
Model	HLG033
Category	Trimmer
Language	English