Vehicle equipment
Please note that this manual contains all
the standard equipment, country-specific
equipment and special equipment for this
model series. Thus, some equipment or
features described in this manual may not
be installed onto your vehicle or are only
available in some markets. For further
configuration information, please refer to
relevant sales information or consult with your
distrib utor s ellin g the v ehicle to yo u.
System introduction
While going downhill, the hill descent control
system (HDC) may actively brake to ensure
that the driver can maintain a constant speed
and drive downhill safely.
⚠ Warning
HDC is intended only to be an aid. At all
times the driver should be responsible for
the safety of the vehicle, and always pay
attention to the surrounding traffic.
In case of the hill is too high, the HDC may
not function and thus the vehicle can't be
driven down the hill at even speed. At this
time, you can control the vehicle speed by
stepping on the brake pedal.
How to use
0AAE711A7C0A
When the power switch is in ON mode or the
vehicle is started, press the button to enable or
disable HDC.
After HDC is turned on, the HDC indicator
on the virtual instrument turns on.
After HDC is turned off, the HDC indicator
on the virtual instrument goes off.
When HDC is working, the HDC indicator
on the virtual instrument flashes.
Notice
It is recommended that HDC should be used
in lower gear.
HDC will be automatically turned off when
the vehicle speed is greater than 60 km/h.
It is still possible to control the vehicle speed
of the vehicle after HDC has been activated
by stepping on the brake pedal or accelerator
pedal.
To Next Page
Loading...
