Vehicle equipment
Please note that this manual contains all
the standard equipment, country-specific
equipment and special equipment for this
model series. Thus, some equipment or
features described in this manual may not
be installed onto your vehicle or are only
available in some markets. For further
configuration information, please refer to
relevant sales information or consult with your
distrib utor s ellin g the v ehicle to yo u.
Air pump and tire repair fluid
DEFEDCAE40C8
Ⓐ Outlet tube
Ⓑ Air inlet
Ⓒ Inflation tube
Ⓓ Air pump switch
Ⓔ Pressure gauge
Ⓕ Power cable
Ⓖ Tire repair liquid
If a tire is punctured by a foreign object
causing a leak, use the air pump and the tire
repair fluid for emergency repair.
Notice
The air pump and the tire repair fluid can
only be used to repair sealed tires with a
puncture on the tread.
The ability of the tire repair fluid to seal tire
walls is limited. If the tire has large cracks,
splits or similar damage, the tire repair fluid
cannot be used to repair the tire.
The tire repair fluid canister must be replaced
after use. You should go to an authorized
service center to have it replaced by a qualified
professional.
⚠ Warning
If the fluid has expired, replace and dispose
of the expired fluid as hazardous waste.
Accidentally consuming tire repair fluid is
harmful to your health. Contact with the skin
can lead to an allergic reaction. If skin contact
occurs, immediately wash the sealant from
your skin with water or soapy water.
Tire repair fluid should be kept out of the
reach of children.
Emergency tire puncture repair
1. If repairing the tires at a location with
vehicles passing, place a warning triangle in
an appropriate position and turn on the
hazard lights.
If the puncture is due to a nail or similar
object, leave ช the object in the tire. This
helps seal the puncture.
2. Ensure that the air pump switch is in the off
state ( “0” position) and then take out the
power cable and tubing.
3. Unscrew the cover of the tire repair liquid air
intake. Screw the inflation tube tightly onto
the air intake of the tire repair liquid, and
screw the air outlet tube of the tire repair
liquid into the air valve of the tire.
⚠ Caution
The inflation tube cannot be bent.
4. Plug the power cable into the 12-volt power
supply socket and start the vehicle.
5. Switch the air pump to the position "I" to start
the air pump, and inflate the tire to 240-250
kPa.
⚠ Caution
Do not stand next to the tire while operating the
air pump. If the tire develops a split or is uneven,
the pump must be turned off immediately.
To Next Page
Loading...
