⚠ Caution
When the Inflator is turned on, the air
pressure will be very high at first, then
decrease slowly, and gradually increase with
the inflation air pressure.
Do not operate the air pump for longer than
10 minutes, otherwise there is a risk of
overheating.
If the tire pressure achieved is less than 17 0
kPa, it indicates that the tire is severely
damaged, so do not continue. At this point,
it is recommended that you contact an
authorized service center as quickly as
possible.
6. Turn off the air pump, remove the power
cable from the 12 volt power socket, and
disconnect the tire repair liquid from the air
valve of the tire.
7. Immediately (within 1 minute) drive at a
speed of 20 to 60 km/h for about 5 km, so
that the tire repair fluid seals the tire evenly.
8. Connect the pump and read the pressure
value on the tire pressure gauge.
A tire pressure of less than 170 kPa indicates
that the tire is not fully sealed. You cannot
continue driving at this time, please
contact an authorized service center as
quickly as possible.
If the tire pressure exceeds 170 kPa, the tire
should be inflated to the tire pressure
indicated on the tire pressure sticker.
9. Turn off the air pump, disconnect the
inflation tube and power cable, and fit the
tire air valve dust cover.
⚠ Caution
After the tire is inflated, the tire air valve dust
cover must be fitted to avoid damage to the tire
air valve being caused by gravel and dust etc.
⚠ Warning
After using the air pump and the tire repair
fluid to repair a tire, do not drive faster than
80 km/h or further than 200 kilometers. It is
recommended that you repair or replace the
damaged tire as soon as possible, and that you
notify the repair technicians that the tire
contains repair liquid.
Tire inflation
If tire pressure is too low, use the air pump to
inflate the tire.
1. Ensure that the air pump is turned off and take
out the power cable and the inflation tube.
2. Screw the inflation tube into the tire air valve.
3. Plug the power cable into the 12 volt power
supply socket and start the vehicle.
4. Switch the air pump to the position "I" to
start inflation.
⚠ Caution
Do not operate the air pump for longer than 10
minutes, otherwise there is a risk of it overheating.
5. The tires should be inflated to the tire
pressure indicated by the type of pressure
sticker.
6. Turn off the air pump, disconnect the
inflation tube and power cable, and fit the
tire air valve dust cover.
To Next Page
Loading...
