There are fuse diagrams on the engine
compartment fuse box cover and dashboard
fuse box cover. Using the diagrams, which
will allow you to determine the relationships
between each fuse and the electronic device
it protects.
Since there may be more than one fuse causing
the fault, it is necessary to examine all of the
fuses that could be at fault before it can be
eliminated. If you are still unable to eliminate
the fault, please contact an authorized service
center to have the fault resolved.
5. Check the wire inside the fuse. If it is blown
out, replace it with a spare fuse with the
same amperage.
6DC672024A26
Ⓐ Normal fuse
Ⓑ Blown fuse
⚠ Warning
Do not attempt to repair the blown fuse or
replace it with one of a different color or rating,
overloaded wiring could catch fire.
6. Check that the electronic device is now
operating normally.
⚠ Caution
If a backup fuse with the same amperage blows
after a short time or the electronic device does
not return to normal operation, this indicates
that the vehicle may have a serious electrical
system fault. At this time, you should
immediately get in touch with an authorized
service center.
Wiper blades
Front wiper blades replacement
Inspect the wiper blades regularly, and replace
the wiper blades if:
The wiper blade is cracked or has stiffened.
The wiper blades leave streaks or do not
clean properly when in use.
⚠ Caution
When lifting the wipers, do not pull the wiper
blade directly to avoid it becoming misshapen
or damaged.
1. Switch the power switch mode to LOCK and
pull the wiper control combination switch
upward for approximately 3 seconds. The
wipers will automatically reach the maintenance
position, as shown in the diagram.
F496C9DD86A4
2. Raise the wiper arm up off the windscreen.
⚠ Caution
If it is necessary to lift the wiper, make sure
it has reached the maintenance position.
Otherwise, the wiper will be damaged.
Do not open the bonnet while the wiper is
being lifted. Otherwise, the bonnet and the
wiper may be damaged.
To Next Page
Loading...
