Heat protection function
After the repeated operation of a window
switch, the heat protection function may be
triggered to protect the window motor. At this
time, the window switch will be temporarily
disabled and it will not be possible to control
or open and close the window. Once the motor
has cooled down, the window switch will
automatically return to normal.
Anti-pinch function
When the window closes automatically, if a
foreign object is detected between the window
frame and the window, the window will stop
closing and open a certain distance automatically.
⚠ Warning
Do not test the anti-pinch function with any
part of your body.
If something gets stuck at the moment the
window closes completely, the anti-pinch
function will not be effective.
Notice
In severe conditions, such as low temperatures
and violent shaking, the anti-pinch function may
be triggered when the window is closing, causing
it to fail to close smoothly. At this time, please
pull up the window switch past the point of
greatest resistance to close the window.
Delay function
Within a few seconds after switching the power
switch to LOCK mode, you still can operate
windows.
Easy close
When the vehicle power switch is in LOCK mode,
and all doors and the tailgate are closed, press
and hold the lock button on the key or touch and
hold the lock sensor on the door handle, and all
windows will close automatically.
When the windows go up automatically,
pressing the lock or unlock buttons on the key
will stop them from going up.
Notice
When the windows go up automatically, if there
is an obstruction between the window and the
window frame, the anti-pinch function may be
triggered. Please confirm that the window is
completely closed before leaving.
Initialization
When errors occur in easy close function, you
can reset it through the following operations:
1. Switch the power switch to ON mode.
2. Raise the one-touch up/down operation
window switch beyond the point of greatest
resistance, until the window closes completely,
and hold for about 3 seconds.
3. Operate the window switch again so that the
window goes through the one-push raising
and one-push lowering.
Notice
When the one touch up/down function is
disordered or the battery is disconnected and
re-energized, the windows with one-push
function need to be initialized.
To Next Page
Loading...
