Turn signal and lane changing signals
B6DD20687049
Ⓐ Lane change signals
Ⓑ Turn signal
Lane change signals: Move the lighting
control combination switch lightly up or
down and release it and the combination
switch will return to its original position and
the corresponding indicator will flash three
times.
Turn signal: Pull up or push down the lighting
control combination switch and release it,
then the lighting control combination switch
will not return automatically and the
corresponding turn signal lamp will flash
continuously.
High/low beam manual switch
565CC4E49B7F
Ⓐ High beam headlamp on
Ⓑ High beam headlamp flashes
When low-beam is on, pushing the lighting
control combination switch away from the
steering wheel will turn the high-beam on or
off. When you release it the combination
switch will return to its original position
automatically.
Pull the lighting control combination switch
towards the steering wheel and the high-beam
will turn on. When you release it, the
combination switch will return to its original
position automatically, and high-beam will
turn off. Repeat this to flash your headlamps.
High/low beam auto switch
07B558A834B1
High and low beam auto switch function can
automatically switch high and low beam lights
based on current vehicle speed and ambient
brightness.
When the low beam headlamp is on and the high
beam headlamp is off, press the switch to
turn on or off the high/low beam auto switch
function. After the function is turned on, the
high/low beam auto switch indicator on the
virtual instrument turns on and displays in
green.
⚠ Warning
High/low beam auto switch function is only an
auxiliary function. When traffic conditions or
weather conditions require, the driver should
manually switch the high and low beam
according to the light and visibility conditions.
Manual intervention is required if:
To Next Page
Loading...
