Vehicle equipment
Please note that this manual contains all
the standard equipment, country-specific
equipment and special equipment for this
model series. Thus, some equipment or
features described in this manual may not
be installed onto your vehicle or are only
av aila bl e in s om e m ark ets . Fo r fur th er
configuration information, please refer to
relevant sales information or consult with your
d i st r ib u to r se l l ing th e v e hi c le to yo u .
Starting the vehicle
Normal startup
1. The driver is carrying the smart key.
2. Adjust seat position and take correct driving
gesture.
3. Confirm that the parking brake has been
applied.
4. Make sure vehicle is in P gear.
5. Step on the brake pedal.
6. Press the power switch to start the vehicle.
(At this time, the indicator READY in the
virtual instrument being on indicates that
the drive system is ready),
Notice
After the vehicle is started, the engine will be
started or stopped automatically according to
the vehicle state.
Emergency startup
D6A8053406FC
When the prompt "check if the key is in the
vehicle" is shown (such the power loss of the
smart key; serious damage to the door handle
or the tailgate and other situations), open the
center armrest and put the smart key on the
mark in the glove box to perform the
normal starting operation of the vehicle, you
will be able to start the vehicle. If the vehicle
will not start, contact an authorized service
center as soon as possible.
⚠ Warning
You must sit in the driver's seat to start the
vehicle. otherwise, a serious or fatal injury
could occur.
When starting the vehicle, do not step on the
accelerator pedal under any circumstances.
If you need to move the vehicle slightly, you
must start the vehicle first, Otherwise, an
accident may occur.
Notice
Try not to store the vehicle in a very cold
environment, as this may cause the vehicle to
fail to start.
To Next Page
Loading...
