⚠ Caution
If braking is maintained (for 8 seconds) after
Launch is activated, the vehicle exits the
Launch function and enters timeout protection
to protect the motor system. Once the timeout
state is entered, you need to release the
accelerator pedal to exit the timeout state to
enter Launch again.
Notice
The high voltage battery temperature may
prevent the normal activation of Launch.
⚠ Warning
Be sure to drive carefully and within the
speed limit.
The function can be used only when you
judge it is safe according to the surrounding
traffic conditions.
Avoid using this function on wet and
slippery roads. Doing so could cause you to
lose control of the vehicle and lead to an
accident.
Park the vehicle
1. After releasing the accelerator pedal, press
on the brake pedal.
2. Once the vehicle has stopped, switch to P
gear.
3. Apply the parking brake and turn the power
switch to LOCK mode.
4. Release the brake pedal.
⚠ Caution
When a vehicle needs to be temporarily
stopped on a slope, the brake pedal must be
pressed or the parking brake must be
applied. Do not use the accelerator pedal or
creep function to prevent the vehicle from
rolling back, Otherwise the transmission will
be damaged.
Do not use the gear P to park on the slope,
otherwise it will damage the transmission.
When the vehicle is parked on a slope, if
necessary use wheel blocks so as to prevent
the vehicle from rolling downhill.
To Next Page
Loading...
