Vehicle equipment
Please note that this manual contains all the standard equipment, country-specific equipment and
special equipment for this model series. Thus, some equipment or features described in this manual
may not be installed onto your vehicle or are only available in some markets. For further
configuration information, please refer to relevant sales information or consult with your distributor
selling the vehicle to you.
Tips for safety
⚠ Warning
The park assist system is intended only as a helpful tool and should not be used in place of the
driver’s own observations of the environment. The driver must always take responsibility for safe
driving and remain alert to the vehicle’s surroundings when parking or performing similar
maneuvers.
The park assist system has blind spots where it may not detect an obstacle. Therefore, ensure that
there are no children or animals near the vehicle when parking or performing similar maneuvers.
⚠ Caution
Ensure that the tailgate is completely closed when reversing.
Do not strike any camera or sensor.
Do not point a high-pressure water hose directly at a camera or sensor when washing the vehicle.
This could result in a system failure or fire.
Do not use any abrasive or sharp object to clean a camera or sensor. Use a soft cloth or low -
pressure water to clean the surface of the cameras and sensors.
Notice
Ultrasonic waves affect the park assist system’s radar, so under the following conditions, it may fail to
detect or detect an obstacle poorly, and this is not a system failure:
When an object is small or fine such as a wire mesh, fence, pillar, or rope.
When the surface of an object does not reflect the detection signal, or a person is wearing clothing that
does not reflect the signal.
When the obstacle is snow, a textile, or a substance whose surface easily absorbs sound waves.
When the obstacle is an acute-angle reflector or a cone-shaped object.
When driving on grassy or bumpy roads.
When reversing on a slope.
When the surroundings have ultrasonic interference at the same frequency, such as from metal or
high-pressure gas emission or when a vehicle horn is sounding directly at the sensor.
When the number plate is bent, tilted or a large decorative number plate frame is installed.
When the sensor’s surface is covered.
To ensure that the system functions properly, make sure that the sensor is clean and does not
have anything covering it, like snow or ice.
To Next Page
Loading...
