EasyManua.ls Logo

Havit H1108 - General Safety Warnings

Havit H1108
9 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
6Turn on the Ozone function
Press the to turn on the Ozone function, the Ozone symbol of ozone indication
area are blue, when the ozone working.
There are ozone smell with the vapor
7Water level alarm system
The water level detection system work during the hot vapor or temperature
reservation system on, when the water stay in the normal status ,the host machine heat
continuously ;when the water level beyond the lowest water level, the host machine will turn off
the heating. And the symbol of the display window will twinkle all the time
And the buzzer sounds the alarm with “Dee Dee” and lock all the button except the “ ‘ button until the
water level back to normal status and stop the buzzer and release button to restart the
‘’
WARMING/VAPOR function.
Attention:
1. Before turn on the power of the host machine, please confirm the water cup was screwed down, the
water level was between the highest and lowest water level mark, and the herbal medicine cover was
covered well in the water hole.
2. If there’s needed to add essential oil under working condition, pleas all it after pause the mist spray.
3. If there’s needed to add herbal medicine package during spray, it has to stop mist spray for one minute to
open herbal cover. Please open the herbal medicine cover one minute after stop the mist spray.
4. It must be clean the cotton pallet in the essential oil base and the herbal medicine package in the herbal
medicine net after stop using aromatherapy or herbal spray everyday.
5. It has to wait the mist came out from the spray hole steady and well-proportionally before facial spray.
6. The spray hole is 40cm away from customer’s face and spray steam should be from customer’s chin to
whole face proportionally to avoid scald the customer’s face due to hot spray steam.
7. Ozone has sterilization effect, but it also will harm skin and destroy nutrients of herbal, so it’s important to
select suitable time for different skin type when using.
8. It’s not allowed to take water cup apart when just finish using spray otherwise will cause scald. Please
wait water cup cold then take it apart.
9. It’s necessary to avoid over adding water, otherwise it’s not only make bad effect to the host machine, but
also may cause the problem of leakage of electricity
10. If there’re problems of water leakage and gas leakage happen underneath the host machine or at the
herbal medicine cover, remember cut off the power of host machine first and then check whether the
water cup or herbal medicine cover well assembled. If the problems still don’t be solved, please contact
local agency for further
Solution:
11. It should have good ground connection for the power plug of host machine.
12. When item H1102 under continuous working mode, if water level under lowest mark without adding water,
the temperature protection system will react right away to cut off the power temporarily. At this time
should add amount of water in time, otherwise temperature protection system would cut power again and