15
1. Starting the engine
a. Press the priming pump continuously until the fuel enters
the pump. Set the switch to position I.
b. Pull the starter chock nob. The starter will close and the
throttle will be moved to the starting position
Hold the chainsaw firmly against the ground. Put the
chainsaw:
∫
Either on the left side of your body holding the handle firmly
with your left hand. Use your right hand to pull the starter
rope
∫
Either on the right side of your body holding the handle
firmly with your right hand.
Use your left hand to pull on the starter rope.
In both cases, the saw must remain away from the operator's
body.
To Next Page
