HAND WIRED
GUITAR AMPLIFIERS
7) Warnings used on this equipment
The exclamation mark contained within a triangle is
intended to alert the user to important operating and
servicing instructions contained in the literature
accompanying this product.
The lightning flash within a triangle is intended to alert the
user to the presence of un-insulated dangerous voltage
within the product enclosure that may be of sufficient
magnitude to constitute a risk of electric shock.
This highlights the presence of dangerous voltages within
the equipment enclosure. Never try to operate the unit out
of the enclosure.
8) Grounding Instructions
This product must be grounded (earthed). If it should
malfunction or break down the grounding provides the path
of east resistance for the electric current, to reduce the risk
of electric shock.
This product is equipped with a power cord which contains
a grounding conductor and a grounding plug. The plug
must be plugged into a compatible mains outlet that is
properly installed and grounded in accordance with the
local electrical safety codes applicable to your country.
DANGER!! Improper connection of the grounding conductor
can result in the possibility of an electric shock. If you are in
any doubt about the ground connection check with a
qualified electrician before using this product. NEVER modify
the mains power cord. Have a suitable mains outlet fitted!
The wires contained within the supplied power cord are
colour coded as follows:
GREEN & YELLOW – GROUND OR EARTH CONDUCTOR
BROWN – LlVE CONDUCTOR
BLUE – NEUTRAL CONDUCTOR
9) Other markings
Other markings appear on the rear panel of the amplifiers
as follows: back of the amplifier has some other markings
on it as follows;
Directs you to recycle this product by taking it to a disposal
area for electronic waste when you have finished with it,
and not dispose of it in the normal household waste.
Indicates that the product contains only the permitted levels
of substances known to be hazardous to your health.
Indicates that the product has been constructed to
European Harmonised Standards and is intended to show
that the product is safe to use. At present, the
manufacturer can self-certify.
Relates to an independent safety testing laboratory and
shows that the product has been subjected to, and passed,
a series of safety and quality tests and indicates that the
product meets all the criteria for sale in Canada and the
USA.
Note:
The CE mark attached to these products means it conforms
to EMC(89/69/EEC) ,(93/68/EEC) and LDV(72/23/EEC).
To Next Page
