USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
Safety Information
WARNING - Read, Understand, and Follow all Instructions in this manual and on the equipment. Failure to follow instructions can cause
death, severe injury and/or serious property damage.
WARNING - Suction Entrapment Hazard. Suction in suction outlets and/or suction outlet covers which are, damaged, broken,
cracked, missing, or unsecured can cause death and/or severe injury due to the following entrapment hazards:
Hair Entrapment - Hair can become entangled in suction outlet cover.
Limb Entrapment - A limb inserted into an opening of a suction outlet sump or suction outlet cover that is damaged, broken, cracked, miss-
ing, or not securely attached can result in a mechanical bind or swelling of the limb.
Body Suction Entrapment - This happens when a negative pressure applied to a large portion of the body or limbs can result in an entrap-
ment.
Evisceration/ Disembowelment - A negative pressure applied directly to the intestines through an unprotected suction outlet sump or suc-
tion outlet cover which is, damaged, broken, cracked, missing, or unsecured can result in evisceration/ disembowelment.
Mechanical Entrapment - There is potential for jewelry, swimsuit, hair decorations, finger, toe or knuckle to be caught in an opening of a
suction outlet cover resulting in mechanical entrapment.
WARNING - To Reduce the risk of Entrapment Hazards:
o When outlets are small enough to be blocked by a person, a minimum of two functioning suction outlets per pump must be installed.
Suction outlets in the same plane (i.e. floor or wall), must be installed a minimum of three feet (3’) [1 meter] apart, as measured from
near point to near point.
o Dual suction fittings shall be placed in such locations and distances to avoid “dual blockage” by a user.
o Dual suction fittings shall not be located on seating areas or on the backrest for such seating areas.
o The maximum system flow rate shall not exceed the flow rating of as listed on Table 1.
o Never use Pool or Spa if any suction outlet component is damaged, broken, cracked, missing, or not attached.
o Replace damaged, broken, cracked, missing, or not securely attached suction outlet components immediately.
o In addition two or more suction outlets per pump installed in accordance with latest ASME, APSP Standards and CPSC guidelines, follow
all National, State, and Local codes applicable.
o Installation of a vacuum release or vent system, which relieves entrapping suction, is recommended.
WARNING - Failure to remove pressure test plugs and/or plugs used in winterization of the pool/spa from the suction outlets can result in
an increase potential for suction entrapment as described above.
WARNING - Failure to keep suction outlet components clear of debris, such as leaves, dirt, hair, paper and other material can result in an
increase potential for suction entrapment as described above.
WARNING - Suction outlet components have a finite life, the cover/grate should be inspected frequently and replaced at least every seven
years or if found to be damaged, broken, cracked, missing, or not securely attached.
CAUTION - Components such as the filtration system, pumps and heater must be positioned so as to prevent their being used as means
of access to the pool by young children. To reduce risk of injury, do not permit children to use or climb on this product. Closely supervise
children at all times. Components such as the filtration system, pumps, and heaters must be positioned to prevent children from using them as
a means of access to the pool.
WARNING - Hazardous Pressure. Pool and spa water heating and circulation systems operate under hazardous pressure during
start up, normal operation, and after pump shut off. Stand clear of circulation system equipment during pump start up. Failure to follow safety
and operation instructions could result in violent separation of the pump housing and cover, and/or filter housing and clamp due to pressure in
the system, which could cause death, severe personal injury and/or property damage, Before servicing pool and spa water circulation system,
all system and pump controls must be in off position and filter manual air relief valve must be in open position. Before starting system pump,
all system valves must be set in a position to allow system water to return back to the pool. Do not change filter control valve position while
system pump is running. Before starting system pump, fully open filter manual air relief valve. Do not close filter manual air relief valve until a
steady stream of water (not air or air and water) is discharged.
WARNING - Separation Hazard. Failure to follow safety and operation instructions could result in violent separation of pump and/
or filter components. Strainer cover must be properly secured to pump housing with strainer cover lock ring. Before servicing pool and spa
To Next Page
Loading...
Need help?
General
