Hayward Pro Series User Manual (English)

Questions and Answers:

S
Seth ShepherdJul 30, 2025
How to fix low water flow in Hayward Swimming Pool Filter?
- L
  Laura AndersonJul 30, 2025
  To address low water flow in your Hayward Swimming Pool Filter, begin by inspecting the skimmer and pump strainer baskets, removing any accumulated debris. Next, check for any obstructions within the intake and discharge lines that may be restricting flow. Also, examine the intake line for potential air leaks, indicated by bubbles returning to the pool. Finally, perform a backwash of the filter to clear any blockages.
A
ajacksonAug 9, 2025
What to do if pool water won't clear up with Hayward Swimming Pool Filter?
- G
  Gary MarshallAug 9, 2025
  If your pool water isn't clearing up with your Hayward Swimming Pool Filter, start by checking the chlorine, pH, and total alkalinity levels, adjusting them as needed to ensure they are within the proper ranges. Verify that the flow rate through the filter is sufficient for effective filtration. Increase the duration of filter operation to allow for more thorough cleaning. Also, make sure that the Vari-Flo valve is correctly set to the 'Filter' position.
S
Seth WoodsAug 19, 2025
Why does my Hayward Swimming Pool Filter have short filter cycles?
- S
  Shawn MartinezAug 20, 2025
  Short filter cycles in your Hayward Swimming Pool Filter could be due to several factors. First, check for algae in the pool and superchlorinate if necessary. Ensure that both chlorine and pH levels are within the proper range, adjusting as needed. Inspect the surface of the filter sand for any crusting or caking, and remove the top 1 inch of sand if this is observed.