USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 3 of 12 Spa Blower ISSPB Rev-A
Basic safety precautions should always be followed, including the following: Failure to follow instructions may result in
injury.
This is the safety-alert symbol. When you see this symbol on your spa blower or in this manual, look for one of
the following signal words, and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property damage
and if ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or property
damage and if ignored presents a potential hazard. It can also make consumers aware of actions that are
unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
1. IMPORTANT SAFETY INSTRUCTIONS
Before installing or servicing this electrical equipment, turn power supply OFF.
WARNING – READ AND FOLLOW ALL INSTRUCTIONS in this owner’s
manual and on the equipment. Failure to follow instructions can cause severe injury and/or death.
WARNING – This product should be installed and serviced only by a qualified professional.
CAUTION – All electrical wiring MUST be in conformance with all applicable local codes, regulations, and
the National Electric Code (NEC).
USE OF NON-HAYWARD REPLACEMENT PARTS VOIDS WARRANTY.
ATTENTION INSTALLER - THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE INSTALLATION,
OPERATION, AND SAFE USE OF THIS SPA BLOWER THAT MUST BE FURNISHED TO THE END USER OF THIS PRODUCT.
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS COULD RESULT IN SERIOUS INJURY.
WARNING – To reduce risk of injury, do not permit children to use or climb on this product. Closely
supervise children at all times. Components such as the filtration system, pumps, heaters and blowers must be
positioned to prevent children from using them as a means of access to the spa.
WARNING – This blower is intended for use on hot tubs and spas. Though this product is designed for
outdoor use, it is strongly advised to protect the electrical components from the weather. Select a well-drained area,
one that will not flood when it rains. It requires free circulation of air for cooling and operation. Do not install in a
damp or non-ventilated location. If installed within an outer enclosure, adequate ventilation and free circulation of
air must be provided to prevent overheating of the motor. Install blower a minimum of two feet (610 mm) off the
ground in a well ventilated location free of debris, chemicals and sprinklers.
WARNING – Risk of electrical shock. Install blower at least five feet (1.5 m) away from tub water using
nonmetallic plumbing. Install blower no less than one foot (305 mm) above the maximum water level to prevent
water from contacting electrical equipment. Install in accordance with the installation instructions.
To Next Page
Loading...