Need help?Do you have a question about the HBM Machines WM180V and is the answer not in the manual?
Crucial safety guidelines for lathe operation and user protection.
Overview of capacities, headstock, feed, and dimensions.
Itemized list of tools included in the lathe's toolbox.
Diagram and guidelines for lathe installation and mounting.
Description of the lathe bed, headstock, carriage, and apron.
Operation of ON/OFF, emergency stop, speed, and direction switches.
How to operate carriage, cross slide, and half nut levers.
Adjusting tailstock clamping, quill, and offset.
Steps for replacing the chuck and setting up the cutting tool.
How to change spindle speed and replace change gears.
Guidelines for straight turning, facing, and between-center turning.
Instructions for taper turning using tailstock offset.
Detailed steps and notes for performing thread cutting.
Details on chucks, drill chuck, and Morse taper arbor.
Benefits and application of the live center for high-speed turning.
Step-by-step guide to setting up and using the steady rest.
Explains the purpose and application of the follow rest.
Procedures for adjusting spindle bearings and slide gibs.
How to adjust the half nut engagement for threading.
Lubrication points for carriage, cross slide, and leadscrew.
Explanation of the lathe's wiring diagram and grounding requirements.
Guidelines for regular cleaning, lubrication, and chip removal.
Table listing common issues and their resolutions.
General| Brand | HBM Machines |
|---|---|
| Model | WM180V |
| Category | Lathe |
| Language | English |
To Next Page